CD74ACT273M96E4

CD74ACT273M96E4 Overview

As a result, it is packaged as SOIC. D flip flop is included in the Tape and Reelpackage. There are 1 elements in it. There are 20 terminations,It is powered from a supply voltage of 5V. In this case, the D flip flop belongs to the ACTfamily. There is an electronic component mounted in the way of Surface Mount. A total of 20pins are provided on this board. This device exhibits a clock edge trigger type of Positive Edge. The part is included in FF/Latches. Considering the reliability of this T flip flop, it is well suited for TR. The power supply is 5V. If high efficiency is desired, the supply voltage should be kept at 5V. In order to operate, the chip has 4 output lines. As a result, it consumes 8μA of quiescent current without being affected by external factors. It is set to -24mAfor the high level output current. It is set to 24mAfor low level output current. Ideally, the operating temperature should be below 125°C. If the operating temperature is higher than -55°C, the system should operate properly. The RS flip flop is designed to operate with a minimal supply voltage of 4.5VV. It is capable of supporting a maximum supply voltage of 5.5V. The frequency that can be achieved is 85MHz. The logic IC it adopts is D FLIP-FLOP. It is equipped with 1 Functions . A total of 20 pins are present on this device. The 24mA output current allows it to be designed with the greatest amount of flexibility.

CD74ACT273M96E4 Features

Tape and Reel package
20 pins
5V power supplies
1 Functions
20 pin count

CD74ACT273M96E4 Applications

There are a lot of Texas Instruments CD74ACT273M96E4 Flip Flops applications.

• ATE
• High Performance Logic for test systems
• Memory
• Convert a momentary switch to a toggle switch
• Single Down Count-Control Line
• Shift registers
• Guaranteed simultaneous switching noise level
• Cold spare funcion
• QML qualified product
• Bounce elimination switch