CD74ACT574M96E4

CD74ACT574M96E4 Overview

The item is packaged in SOICcases. The package Tape & Reel (TR)contains it. In total, there are 1 elements. There are 20 terminations,The D flip flop is powered by a voltage of 5V . In this case, the D flip flop belongs to the ACTfamily. There is an electronic component mounted in the way of Surface Mount. There are 20pins on it. This device's clock edge trigger type is Positive Edge. The part is included in Bus Driver/Transceiver. In light of its reliable performance, this T flip flop is well suited for TR. It runs on 5Vvolts of power. The D flip flop has no ports embedded. If high efficiency is to be achieved, the supply voltage should be maintained at 5V. It operates with 3 output lines. It consumes 8μA of quiescent current without being affected by external factors. -24mAis the output current at high level. A 24mAvalue is set for low-level output current. Temperatures below 125°Care ideal for operating. Temperatures above -55°Cshould be used. The system operates with a minimum supply voltage of 4.5V. 5.5Vis the maximum supply voltage supported by it. This frequency can be achieved at 110MHz. In this case, it uses a BUS DRIVER logic IC. There are 1 functions available on this T flip flop. The D latch is equipped with 20 pins. 24mA provides maximum design flexibility due to its output current.

CD74ACT574M96E4 Features

Tape & Reel (TR) package
20 pins
5V power supplies
1 Functions
20 pin count

CD74ACT574M96E4 Applications

There are a lot of Texas Instruments CD74ACT574M96E4 Flip Flops applications.

• Data Synchronizers
• Registers
• Single Down Count-Control Line
• Supports Live Insertion
• Synchronous counter
• Asynchronous counter
• Balanced 24 mA output drivers
• Divide a clock signal by 2 or 4
• Memory
• Buffered Clock