CD74HC74MT

CD74HC74MT Overview

The package is in the form of 14-SOIC (0.154, 3.90mm Width). It is contained within the Tape & Reel (TR)package. The output it is configured with uses Differential. It is configured with a trigger that uses a value of Positive Edge. The electronic part is mounted in the way of Surface Mount. A 2V~6Vsupply voltage is required for it to operate. In this case, the operating temperature is -55°C~125°C TA. This logic flip flop is classified as type D-Type. It is a type of FPGA belonging to the 74HC series. There should be no greater frequency than 50MHzon its output. There are 14 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. Members of the 74HC74family make up this object. The power source is powered by 4.5V. The input capacitance of this T flip flop is 10pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. A device of this type belongs to the family of HC/UH. It is mounted by the way of Surface Mount. This board is designed with 14pins on it. Its clock edge trigger type is Positive Edge. This device is part of the FF/Latchesbase part number family. It reaches 6Vwhen the maximum supply voltage (Vsup) is applied. Normally, the supply voltage (Vsup) should be kept above 2V. To achieve this superior flexibility, 2 circuits are used. As a result of its reliable performance, this T flip flop is suitable for TR. It offers maximum design flexibility with its output current of 5.2mA. To operate, the chip has a total of 1 output lines. It consumes 4μA current.

CD74HC74MT Features

Tape & Reel (TR) package
74HC series
14 pins

CD74HC74MT Applications

There are a lot of Texas Instruments CD74HC74MT Flip Flops applications.

• Computers
• Divide a clock signal by 2 or 4
• Bounce elimination switch
• Consumer
• Guaranteed simultaneous switching noise level
• Computing
• Shift Registers
• Load Control
• Registers
• CMOS Process