CD74HCT109MT

CD74HCT109MT Overview

In the form of 16-SOIC (0.154, 3.90mm Width), it has been packaged. It is contained within the Tape & Reel (TR)package. The output it is configured with uses Differential. JK flip flop uses Positive Edgeas the trigger. There is an electronic component mounted in the way of Surface Mount. A voltage of 4.5V~5.5Vis used as the supply voltage. In the operating environment, the temperature is -55°C~125°C TA. A flip flop of this type is classified as a JK Type. In FPGA terms, D flip flop is a type of 74HCTseries FPGA. Its output frequency should not exceed 54MHz. T flip flop consumes 4μA quiescent energy. There are 16 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. It is a member of the 74HCT109 family. It is powered from a supply voltage of 5V. Its input capacitance is 10pF farads. An electronic device belonging to the family HCTcan be found here. Surface Mount mounts this electronic component. A total of 16pins are provided on this board. Its clock edge trigger type is Positive Edge. It is included in FF/Latches. Its flexibility is enhanced by 2 circuits. Considering the reliability of this T flip flop, it is well suited for TAPE AND REEL. The D latch runs on a voltage of 5V volts. High efficiency requires the supply voltage to be maintained at 5V. With a current output of 4mA , it offers maximum design flexibility.

CD74HCT109MT Features

Tape & Reel (TR) package
74HCT series
16 pins
5V power supplies

CD74HCT109MT Applications

There are a lot of Texas Instruments CD74HCT109MT Flip Flops applications.

• Single Down Count-Control Line
• Buffer registers
• 2 – Bit synchronous counter
• CMOS Process
• Test & Measurement
• Common Clocks
• Count Modes
• Frequency Divider circuits
• Circuit Design
• Memory