CD74HCT173M96

CD74HCT173M96 Overview

The package is in the form of 16-SOIC (0.154, 3.90mm Width). You can find it in the Tape & Reel (TR)package. There is a Tri-State, Non-Invertedoutput configured with it. Positive Edgeis the trigger it is configured with. Surface Mountis occupied by this electronic component. The JK flip flop operates at a voltage of 4.5V~5.5V. In the operating environment, the temperature is -55°C~125°C TA. The type of this D latch is D-Type. In FPGA terms, D flip flop is a type of 74HCTseries FPGA. Its output frequency should not exceed 60MHz Hz. A total of 1 elements are present. Terminations are 16. The object belongs to the 74HCT173 family. Power is provided by a 5V supply. A JK flip flop with a 10pFfarad input capacitance is used here. An electronic device belonging to the family HCTcan be found here. There is an electronic component mounted in the way of Surface Mount. Basically, it is designed with a set of 16 pins. A Positive Edgeclock edge trigger is used in this device. It is included in FF/Latches. It is designed with a number of bits of 4. The superior flexibility is achieved through the use of 4 circuits. A reliable performance of this D flip flop makes it well suited for use in TR. It runs on 5Vvolts of power. If high efficiency is to be achieved, the supply voltage should be maintained at 5V. It is designed with 3 output lines. There is a consumption of 8μAof quiescent current from it. Additionally, you may refer to the D latch's additional WITH DUAL OUTPUT ENABLE.

CD74HCT173M96 Features

Tape & Reel (TR) package
74HCT series
16 pins
4 Bits
5V power supplies

CD74HCT173M96 Applications

There are a lot of Texas Instruments CD74HCT173M96 Flip Flops applications.

• Frequency Dividers
• Frequency Divider circuits
• Data storage
• Instrumentation
• Test & Measurement
• Digital electronics systems
• Supports Live Insertion
• Dynamic threshold performance
• Parallel data storage
• Shift registers