CD74HCT273M96

CD74HCT273M96 Overview

The flip flop is packaged in a case of 20-SOIC (0.295, 7.50mm Width). It is contained within the Cut Tape (CT)package. This output is configured with Non-Inverted. It is configured with a trigger that uses a value of Positive Edge. Surface Mountis occupied by this electronic component. The JK flip flop operates with an input voltage of 4.5V~5.5V volts. In this case, the operating temperature is -55°C~125°C TA. There is D-Type type of electronic flip flop associated with this device. The 74HCTseries comprises this type of FPGA. There should be no greater frequency than 50MHzon its output. In total, it contains 1 elements. There have been 20 terminations. This D latch belongs to the family of 74HCT273. The D flip flop is powered by a voltage of 5V . A JK flip flop with a 10pFfarad input capacitance is used here. Devices in the HCTfamily are electronic devices. This electronic part is mounted in the way of Surface Mount. The electronic flip flop is designed with pins 20. In this device, the clock edge trigger type is Positive Edge. The RS flip flops belongs to FF/Latches base part number. 8bits are used in its design. Its flexibility is enhanced by 8 circuits. This D flip flop is well suited for TR based on its reliable performance. It runs on 5Vvolts of power. For high efficiency, the supply voltage should be set to 5V. It consumes a total of 8μA quiescent current at any given time.

CD74HCT273M96 Features

Cut Tape (CT) package
74HCT series
20 pins
8 Bits
5V power supplies

CD74HCT273M96 Applications

There are a lot of Texas Instruments CD74HCT273M96 Flip Flops applications.

• Asynchronous counter
• Pattern generators
• Buffered Clock
• Consumer
• Bus hold
• Single Up Count-Control Line
• 2 – Bit synchronous counter
• Memory
• Individual Asynchronous Resets
• Cold spare funcion