CD74HCT374M

CD74HCT374M Overview

As a result, it is packaged as 20-SOIC (0.295, 7.50mm Width). The Tubepackage contains it. Tri-State, Non-Invertedis the output configured for it. The trigger configured with it uses Positive Edge. In this case, the electronic component is mounted in the way of Surface Mount. A voltage of 4.5V~5.5Vis used as the supply voltage. It is operating at a temperature of -55°C~125°C TA. D-Typeis the type of this D latch. JK flip flop is a part of the 74HCTseries of FPGAs. In order for it to function properly, its output frequency should not exceed 60MHz. In total, there are 1 elements. Currently, there are 20 terminations. The 74HCT374family includes it. The D flip flop is powered by a voltage of 5V . A JK flip flop with a 10pFfarad input capacitance is used here. This D flip flop belongs to the family of HCT. It is mounted in the way of Surface Mount. With its 20pins, it is designed to work with most electronic flip flops. This device's clock edge trigger type is Positive Edge. The part you are looking for is included in FF/Latches. It is designed with 8bits. In order to achieve its superior flexibility, 8 circuits are used. The D latch runs on a voltage of 5V volts. A D flip flop with 2embedded ports is available. In order to achieve high efficiency, the supply voltage should be maintained at 5V. As a result of its output current of 6mA, it is very flexible in terms of design. To operate, the chip has a total of 3 output lines. There is a consumption of 8μAof quiescent current from it.

CD74HCT374M Features

Tube package
74HCT series
20 pins
8 Bits
5V power supplies

CD74HCT374M Applications

There are a lot of Texas Instruments CD74HCT374M Flip Flops applications.

• Synchronous counter
• Control circuits
• Shift registers
• Single Down Count-Control Line
• Latch
• Balanced Propagation Delays
• High Performance Logic for test systems
• Memory
• CMOS Process
• ATE