CLVC1G175MDCKREPG4

CLVC1G175MDCKREPG4 Overview

As a result, it is packaged as 6-TSSOP, SC-88, SOT-363. It is contained within the Tape & Reel (TR)package. As configured, the output uses Non-Inverted. In the configuration of the trigger, Positive Edgeis used. Surface Mountmounts this electrical part. The JK flip flop operates at 1.65V~5.5Vvolts. A temperature of -55°C~125°C TAis used in the operation. It belongs to the type D-Typeof flip flops. In this case, it is a type of FPGA belonging to the 74LVC series. There should be no greater frequency than 175MHzon its output. 6terminations have occurred. You can search similar parts based on 74LVC1G175. Power is provided by a 1.8V supply. This JK flip flop has a 3pFfarad input capacitance. An electronic device belonging to the family LVC/LCX/Zcan be found here. There is an electronic part mounted in the way of Surface Mount. As you can see from the design, it has pins with 6. There is a clock edge trigger type of Positive Edgeon this device. This part is included in FF/Latches. It is designed with a number of bits of 1. It reaches the maximum supply voltage (Vsup) at 5.5V. Its flexibility is enhanced by 1 circuits. As a result of its reliability, this D flip flop is ideally suited for TR. An electrical current of 3.3V volts is applied to it. It consumes a total of 10μA quiescent current at any given time.

CLVC1G175MDCKREPG4 Features

Tape & Reel (TR) package
74LVC series
6 pins
1 Bits
3.3V power supplies

CLVC1G175MDCKREPG4 Applications

There are a lot of Texas Instruments CLVC1G175MDCKREPG4 Flip Flops applications.

• Computers
• Data transfer
• Latch
• Counters
• Consumer
• Patented noise
• Guaranteed simultaneous switching noise level
• Frequency Divider circuits
• Frequency Dividers
• Bounce elimination switch