CY74FCT162374TPVC

CY74FCT162374TPVC Overview

The package is in the form of 48-BSSOP (0.295, 7.50mm Width). As part of the package Tube, it is embedded. Currently, the output is configured to use Tri-State, Non-Inverted. It is configured with a trigger that uses a value of Positive Edge. Surface Mountis in the way of this electric part. A 4.5V~5.5Vsupply voltage is required for it to operate. Currently, the operating temperature is -40°C~85°C TA. D-Typeis the type of this D latch. In FPGA terms, D flip flop is a type of 74FCTseries FPGA. A total of 2 elements are present. T flip flop consumes 500μA quiescent energy. There are 48 terminations,This D latch belongs to the family of 74FCT162374. Power is provided by a 5V supply. The input capacitance of this JK flip flopis 4.5pF farads. Electronic devices of this type belong to the FCTfamily. There is an electronic component mounted in the way of Surface Mount. Basically, it is designed with a set of 48 pins. A Positive Edgeclock edge trigger is used in this device. This device is part of the FF/Latchesbase part number family. The design is based on 16bits. Using 1 circuits, it is highly flexible. An electrical current of 5V volts is applied to it. The D flip flop has no ports embedded. The supply voltage should be maintained at 5V for high efficiency. With a current output of 24mA , it offers maximum design flexibility. There are 8 output lines in this JK flip flop.

CY74FCT162374TPVC Features

Tube package
74FCT series
48 pins
16 Bits
5V power supplies

CY74FCT162374TPVC Applications

There are a lot of Texas Instruments CY74FCT162374TPVC Flip Flops applications.

• Modulo – n – counter
• Common Clocks
• Latch-up performance
• Single Up Count-Control Line
• Count Modes
• Shift registers
• Communications
• Storage Registers
• Convert a momentary switch to a toggle switch
• Single Down Count-Control Line