CY74FCT16823CTPVC

CY74FCT16823CTPVC Overview

The flip flop is packaged in 56-BSSOP (0.295, 7.50mm Width). As part of the package Tube, it is embedded. The output it is configured with uses Tri-State, Non-Inverted. In the configuration of the trigger, Positive Edgeis used. This electronic part is mounted in the way of Surface Mount. A voltage of 4.5V~5.5Vis used as the supply voltage. -40°C~85°C TAis the operating temperature. It belongs to the type D-Typeof flip flops. In FPGA terms, D flip flop is a type of 74FCTseries FPGA. D latch consists of 2 elements. Despite external influences, it consumes 500μAof quiescent current. There are 56 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. The 74FCT16823family includes it. Power is supplied from a voltage of 5V volts. There is 4.5pF input capacitance for this T flip flop. This D flip flop belongs to the family of FCT. Electronic part Surface Mountis mounted in the way. Basically, it is designed with a set of 56 pins. This device exhibits a clock edge trigger type of Positive Edge. This part is included in FF/Latches. There are 18bits in this flip flop. The system runs on a power supply of 5V watts. This D flip flop is equipped with 0 ports. High efficiency requires the supply voltage to be maintained at 5V. As a result of its output current of 64mA, it is very flexible in terms of design. In order for the chip to function, it has 9output lines. It consumes 5μA current.

CY74FCT16823CTPVC Features

Tube package
74FCT series
56 pins
18 Bits
5V power supplies

CY74FCT16823CTPVC Applications

There are a lot of Texas Instruments CY74FCT16823CTPVC Flip Flops applications.

• Load Control
• Guaranteed simultaneous switching noise level
• Storage registers
• Test & Measurement
• Registers
• Individual Asynchronous Resets
• Count Modes
• Computing
• Convert a momentary switch to a toggle switch
• Asynchronous counter