CY74FCT2374ATQCT

CY74FCT2374ATQCT Overview

It is embeded in 20-SSOP (0.154, 3.90mm Width) case. It is contained within the Tape & Reel (TR)package. T flip flop uses Tri-State, Non-Invertedas its output configuration. It is configured with a trigger that uses Positive Edge. This electronic part is mounted in the way of Surface Mount. The supply voltage is set to 4.75V~5.25V. It is operating at a temperature of -40°C~85°C TA. D-Typedescribes this flip flop. In FPGA terms, D flip flop is a type of 74FCTseries FPGA. A frequency of 250MHzshould be the maximum output frequency. A total of 1elements are present in it. As a result, it consumes 200μA quiescent current. It has been determined that there have been 20 terminations. D latch belongs to the 74FCT2374 family. An input voltage of 5Vpowers the D latch. A JK flip flop with a 5pFfarad input capacitance is used here. FCTis the family of this D flip flop. It is mounted by the way of Surface Mount. A total of 20pins are provided on this board. This device exhibits a clock edge trigger type of Positive Edge. It is included in FF/Latches. It is designed with 8bits. Due to its superior flexibility, it uses 8 circuits. Considering the reliability of this T flip flop, it is well suited for TAPE AND REEL. An electrical current of 5V volts is applied to it. A total of 2ports are embedded in the D flip flop. The supply voltage should be maintained at 5V for high efficiency. In addition to its maximum design flexibility, the output current of the T flip flop is 12mA. The JK flip flop is with 3 output lines to operate.

CY74FCT2374ATQCT Features

Tape & Reel (TR) package
74FCT series
20 pins
8 Bits
5V power supplies

CY74FCT2374ATQCT Applications

There are a lot of Texas Instruments CY74FCT2374ATQCT Flip Flops applications.

• Parallel data storage
• Safety Clamp
• Instrumentation
• 2 – Bit synchronous counter
• High Performance Logic for test systems
• Latch-up performance
• Control circuits
• Test & Measurement
• Computers
• Automotive