CY74FCT2374ATSOC

CY74FCT2374ATSOC Overview

The flip flop is packaged in 20-SOIC (0.295, 7.50mm Width). D flip flop is embedded in the Tube package. T flip flop is configured with an output of Tri-State, Non-Inverted. It is configured with a trigger that uses Positive Edge. Surface Mountis in the way of this electric part. A supply voltage of 4.75V~5.25V is required for operation. -40°C~85°C TAis the operating temperature. A flip flop of this type is classified as a D-Type. In FPGA terms, D flip flop is a type of 74FCTseries FPGA. This D flip flop should not have a frequency greater than 250MHz. In total, there are 1 elements. T flip flop consumes 200μA quiescent energy. It has been determined that there have been 20 terminations. If you search by 74FCT2374, you will find similar parts. It is powered from a supply voltage of 5V. JK flip flop input capacitance is 5pF farads. In terms of electronic devices, this device belongs to the FCTfamily of devices. There is an electronic part that is mounted in the way of Surface Mount. The electronic flip flop is designed with pins 20. The clock edge trigger type for this device is Positive Edge. This part is included in Bus Driver/Transceiver. It is designed with a number of bits of 8. Its superior flexibility is attributed to its use of 8 circuits. The power supply is 5V. This flip flop has a total of 2ports. In order to achieve high efficiency, the supply voltage should be maintained at 5V. There are no output lines on the JK flip flop.

CY74FCT2374ATSOC Features

Tube package
74FCT series
20 pins
8 Bits
5V power supplies

CY74FCT2374ATSOC Applications

There are a lot of Texas Instruments CY74FCT2374ATSOC Flip Flops applications.

• Single Down Count-Control Line
• Balanced 24 mA output drivers
• Matched Rise and Fall
• CMOS Process
• Guaranteed simultaneous switching noise level
• Cold spare funcion
• Parallel data storage
• Digital electronics systems
• Bus hold
• Latch