CY74FCT2374ATSOCE4

CY74FCT2374ATSOCE4 Overview

As a result, it is packaged as 20-SOIC (0.295, 7.50mm Width). D flip flop is included in the Tubepackage. Tri-State, Non-Invertedis the output configured for it. This trigger is configured to use Positive Edge. In this case, the electronic component is mounted in the way of Surface Mount. The JK flip flop operates at 4.75V~5.25Vvolts. It is operating at -40°C~85°C TA. A flip flop of this type is classified as a D-Type. It belongs to the 74FCTseries of FPGAs. You should not exceed 250MHzin the output frequency of the device. In total, it contains 1 elements. As a result, it consumes 200μA quiescent current. A total of 20terminations have been recorded. It is a member of the 74FCT2374 family. It is powered by a voltage of 5V . JK flip flop input capacitance is 5pF farads. It belongs to the family of electronic devices known as FCT. There is an electronic component mounted in the way of Surface Mount. With its 20pins, it is designed to work with most electronic flip flops. This device exhibits a clock edge trigger type of Positive Edge. This RS flip flops is a part number FF/Latches. This flip flop is designed with 8 Bits. Vsup reaches its maximum value at 5.25V. A normal operating voltage (Vsup) should remain above 4.75V. The D latch runs on a voltage of 5V volts. There are 2 ports embedded in the flip flops. There are no output lines on the JK flip flop. As of now, there are 8input lines.

CY74FCT2374ATSOCE4 Features

Tube package
74FCT series
20 pins
8 Bits
5V power supplies

CY74FCT2374ATSOCE4 Applications

There are a lot of Texas Instruments CY74FCT2374ATSOCE4 Flip Flops applications.

• ESD performance
• Bounce elimination switch
• Latch-up performance
• Instrumentation
• Asynchronous counter
• Pattern generators
• Registers
• QML qualified product
• Cold spare funcion
• Digital electronics systems