CY74FCT2374CTSOCT

CY74FCT2374CTSOCT Overview

It is packaged in the way of 20-SOIC (0.295, 7.50mm Width). Package Tape & Reel (TR)embeds it. Tri-State, Non-Invertedis the output configured for it. In the configuration of the trigger, Positive Edgeis used. Surface Mountmounts this electrical part. A supply voltage of 4.75V~5.25V is required for operation. It is operating at -40°C~85°C TA. A flip flop of this type is classified as a D-Type. In FPGA terms, D flip flop is a type of 74FCTseries FPGA. Its output frequency should not exceed 250MHz. D latch consists of 1 elements. As a result, it consumes 200μA quiescent current and is not affected by external forces. There have been 20 terminations. JK flip flop belongs to 74FCT2374 family. The power supply voltage is 5V. A 5pFfarad input capacitance is provided by this T flip flop. It belongs to the family of electronic devices known as FCT. There is an electronic part that is mounted in the way of Surface Mount. This board has 20 pins. There is a clock edge trigger type of Positive Edgeon this device. It is part of the FF/Latchesbase part number family. There are 8bits in its design. 5.25Vis the maximum supply voltage (Vsup). Normally, the supply voltage (Vsup) should be kept above 4.75V. A reliable performance of this D flip flop makes it well suited for use in TAPE AND REEL. It runs on 5Vvolts of power. There are 2 ports embedded in the flip flops. The output current of 12mA makes it feature maximum design flexibility. There are 3 output lines on it. Currently, there are 8 input lines present.

CY74FCT2374CTSOCT Features

Tape & Reel (TR) package
74FCT series
20 pins
8 Bits
5V power supplies

CY74FCT2374CTSOCT Applications

There are a lot of Texas Instruments CY74FCT2374CTSOCT Flip Flops applications.

• ESD protection
• Frequency division
• Registers
• Communications
• Circuit Design
• Supports Live Insertion
• Storage Registers
• Balanced Propagation Delays
• Common Clocks
• Buffered Clock