CY74FCT273TQCT

CY74FCT273TQCT Overview

The package is in the form of 20-SSOP (0.154, 3.90mm Width). D flip flop is embedded in the Tape & Reel (TR) package. It is configured with Non-Invertedas an output. The trigger it is configured with uses Positive Edge. It is mounted in the way of Surface Mount. It operates with a supply voltage of 4.75V~5.25V. In the operating environment, the temperature is -40°C~85°C TA. Logic flip flops of this type are classified as D-Type. In terms of FPGAs, it belongs to the 74FCT series. The element count is 1 . There is 200μA quiescent consumption. A total of 20terminations have been recorded. The object belongs to the 74FCT273 family. A voltage of 5V provides power to the D latch. The input capacitance of this JK flip flopis 5pF farads. FCTis the family of this D flip flop. It is mounted by the way of Surface Mount. Basically, it is designed with a set of 20 pins. It has a clock edge trigger type of Positive Edge. There is a FF/Latchesbase part number assigned to the RS flip flops. There are 8bits in its design. This D flip flop is well suited for TR based on its reliable performance. A total of 5V power supplies are needed to run it. A high level of efficiency can be achieved by maintaining the supply voltage at 5V. With an output current of 64mA, it is possible to design the device in any way you want. It has 8lines.

CY74FCT273TQCT Features

Tape & Reel (TR) package
74FCT series
20 pins
8 Bits
5V power supplies

CY74FCT273TQCT Applications

There are a lot of Texas Instruments CY74FCT273TQCT Flip Flops applications.

• Guaranteed simultaneous switching noise level
• ATE
• Data storage
• Single Up Count-Control Line
• Count Modes
• High Performance Logic for test systems
• Functionally equivalent to the MC10/100EL29
• 2 – Bit synchronous counter
• Data transfer
• Test & Measurement