CY74FCT374CTSOC

CY74FCT374CTSOC Overview

The item is packaged in 20-SOIC (0.295, 7.50mm Width)cases. There is an embedded version in the package Tube. T flip flop is configured with an output of Tri-State, Non-Inverted. The trigger configured with it uses Positive Edge. Surface Mountis occupied by this electronic component. Powered by a 4.75V~5.25Vvolt supply, it operates as follows. The operating temperature is -40°C~85°C TA. This D latch has the type D-Type. It is a type of FPGA belonging to the 74FCT series. A frequency of 250MHzshould not be exceeded by its output. A total of 1elements are contained within it. This process consumes 200μA quiescents. Currently, there are 20 terminations. It is a member of the 74FCT374 family. An input voltage of 5Vpowers the D latch. Its input capacitance is 5pFfarads. The electronic device belongs to the FCTfamily. In this case, the electronic component is mounted in the way of Surface Mount. As you can see from the design, it has pins with 20. The clock edge trigger type for this device is Positive Edge. The RS flip flops belongs to FF/Latches base part number. Flip flops designed with 8bits are used in this part. 8 circuits are used to achieve its superior flexibility. In order for the device to operate, it requires 5V power supplies. There are 2 ports embedded in the flip flops. High efficiency requires the supply voltage to be maintained at 5V. In addition to its maximum design flexibility, the output current of the T flip flop is 64mA. It is designed with 3 output lines.

CY74FCT374CTSOC Features

Tube package
74FCT series
20 pins
8 Bits
5V power supplies

CY74FCT374CTSOC Applications

There are a lot of Texas Instruments CY74FCT374CTSOC Flip Flops applications.

• Functionally equivalent to the MC10/100EL29
• High Performance Logic for test systems
• Safety Clamp
• CMOS Process
• Digital electronics systems
• Frequency Dividers
• Balanced 24 mA output drivers
• 2 – Bit synchronous counter
• Control circuits
• Single Up Count-Control Line