CY74FCT377ATQCT

CY74FCT377ATQCT Overview

It is packaged in the way of 20-SSOP (0.154, 3.90mm Width). Package Tape & Reel (TR)embeds it. T flip flop uses Non-Invertedas its output configuration. This trigger uses the value Positive Edge. This electronic part is mounted in the way of Surface Mount. A voltage of 4.75V~5.25Vis required for its operation. The operating temperature is -40°C~85°C TA. Logic flip flops of this type are classified as D-Type. It belongs to the 74FCTseries of FPGAs. D latch consists of 1 elements. 20terminations have occurred. This D latch belongs to the family of 74FCT377. A voltage of 5V is used to power it. The input capacitance of this T flip flop is 5pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. A device of this type belongs to the family of FCT. It is mounted by the way of Surface Mount. This board is designed with 20pins on it. In this device, the clock edge trigger type is Positive Edge. It is included in FF/Latches. An electronic part designed with 8bits is used in this application. As a result of its reliable performance, this T flip flop is suitable for TR. A power supply of 5Vis required to operate it. For high efficiency, the supply voltage should be kept at 5V. The 64mA output current allows it to be designed with the greatest amount of flexibility. As of now, there are 8input lines. This D latch consumes 200μA quiescent current at all.

CY74FCT377ATQCT Features

Tape & Reel (TR) package
74FCT series
20 pins
8 Bits
5V power supplies

CY74FCT377ATQCT Applications

There are a lot of Texas Instruments CY74FCT377ATQCT Flip Flops applications.

• Dynamic threshold performance
• Modulo – n – counter
• Latch-up performance
• ATE
• Bounce elimination switch
• QML qualified product
• High Performance Logic for test systems
• Reduced system switching noise
• Single Down Count-Control Line
• CMOS Process