DM74ALS175M

DM74ALS175M Overview

The flip flop is packaged in 16-SOIC (0.154, 3.90mm Width). It is included in the package Tube. T flip flop uses Differentialas its output configuration. It is configured with a trigger that uses Positive Edge. In this case, the electronic component is mounted in the way of Surface Mount. The supply voltage is set to 4.5V~5.5V. It is operating at 0°C~70°C TA. Logic flip flops of this type are classified as D-Type. In this case, it is a type of FPGA belonging to the 74ALS series. Its output frequency should not exceed 50MHz Hz. The list contains 1 elements. During its operation, it consumes 14mA quiescent energy. The 74ALS175family includes it. A part of the electronic system is mounted in the way of Surface Mount. Basically, it is designed with a set of 16 pins. This device exhibits a clock edge trigger type of Positive Edge. 4bits are used in its design. The superior flexibility of this product is achieved by using 4 circuits. High efficiency requires the supply voltage to be maintained at 5V. There are no output lines on the JK flip flop. The number of input lines is 4. It is set to -400μAfor the high level output current. The low level output current is set to 8mA. It is recommended that the operating temperature be lower than 70°C. In order for the system to operate properly, the temperature should be higher than 0°C. Despite its minimal supply voltage of 4.5V, it is capable of operating. 5.5Vis the maximum supply voltage it supports. It is possible to achieve a frequency of 50MHz.

DM74ALS175M Features

Tube package
74ALS series
16 pins
4 Bits

DM74ALS175M Applications

There are a lot of ON Semiconductor DM74ALS175M Flip Flops applications.

• Divide a clock signal by 2 or 4
• CMOS Process
• Consumer
• Counters
• Storage Registers
• Power down protection
• Shift registers
• High Performance Logic for test systems
• Parallel data storage
• ATE