DM74ALS373N

DM74ALS373N Overview

It is embedded in the 20-DIP (0.300, 7.62mm) package. A Tube package is used to package it. It uses the output configuration Tri-State. This electrical device has Logic type D-Type Transparent Latch. Mounting this electronic component follows the Through Hole method. The supply voltage of the device is 4.5V~5.5V. It operates at 0°C~70°C degrees Celsius. 74ALS is the series number of this FPGA. The electronic part in this image has 8 bits. 74ALS373 is its family. The 20 pins are designed into it. The electronic part is mounted in a way that corresponds to Through Hole. There are 3 input Lines, which consist of an electronic circuit connected between the ac mains and the rectifier input stage of the switching power supply. Its 24mA output current allows for maximum design flexibility. High efficiency requires a supply voltage of 5V. 3 output lines generate the binary equivalent of the input lines. The current consumed by the device is 16mA volts in quiescent mode, which cannot be affected by external factors. It consists of 1 elements. 8 circuits enable it to achieve high performance. 2.6mA is set as the low level output current. It is set to zero for the high level output current. The operating temperature should be lower than 70°C. Temperatures higher than 0°C should be used for operation. It supports a maximum supply voltage of 5.5V. A minimal voltage of 4.5V is needed to operate it.

DM74ALS373N Features

20-DIP (0.300, 7.62mm) package
74ALS series
8 Bits
74ALS373 family
20 pins
1 elements

DM74ALS373N Applications

There are a lot of ON Semiconductor DM74ALS373N Latches applications.

• Buffer/Storage Registers
• Parallel-to-Serial Data Conversion
• Relay
• Counter
• Counters
• Flip-flops
• Stacked or Push-Down Registers
• Hammer
• Avionics
• OC-48 communication systems