DM74ALS374WM

DM74ALS374WM Overview

The flip flop is packaged in a case of 20-SOIC (0.295, 7.50mm Width). D flip flop is included in the Tubepackage. In the configuration, Tri-State, Non-Invertedis used as the output. There is a trigger configured with Positive Edge. Surface Mountis occupied by this electronic component. A 4.5V~5.5Vsupply voltage is required for it to operate. It is operating at a temperature of 0°C~70°C TA. A flip flop of this type is classified as a D-Type. It is a type of FPGA belonging to the 74ALS series. You should not exceed 35MHzin its output frequency. In total, there are 1 elements. It consumes 19mA of quiescent This D latch belongs to the family of 74ALS374. There is an electronic component mounted in the way of Surface Mount. With its 20pins, it is designed to work with most electronic flip flops. The clock edge trigger type for this device is Positive Edge. This flip flop is designed with 8 Bits. The superior flexibility of this circuit is achieved by using 8 circuits. For high efficiency, the supply voltage should be kept at 5V. It has 3 output lines to operate. A total of 3input lines have been provided. -2.6mAis the output current at high level. There is 24mA output current at the low level. A temperature below 70°Cis recommended for operation. In order for the system to operate properly, the temperature should be higher than 0°C. The minimum voltage required for operation is 4.5V. It supports the maximal supply voltage of 5.5V. A frequency of 35MHzcan be achieved.

DM74ALS374WM Features

Tube package
74ALS series
20 pins
8 Bits

DM74ALS374WM Applications

There are a lot of ON Semiconductor DM74ALS374WM Flip Flops applications.

• CMOS Process
• Balanced Propagation Delays
• ESCC
• Data transfer
• Automotive
• Clock pulse
• Matched Rise and Fall
• Cold spare funcion
• Modulo – n – counter
• Test & Measurement