DM74ALS534WM

DM74ALS534WM Overview

The flip flop is packaged in a case of 20-SOIC (0.295, 7.50mm Width). It is included in the package Tube. There is a Tri-State, Invertedoutput configured with it. There is a trigger configured with Positive Edge. There is an electric part mounted in the way of Surface Mount. A supply voltage of 4.5V~5.5V is required for operation. It is operating at a temperature of 0°C~70°C TA. This D latch has the type D-Type. JK flip flop is a part of the 74ALSseries of FPGAs. You should not exceed 35MHzin its output frequency. The list contains 1 elements. There is a consumption of 19mAof quiescent energy. Members of the 74ALS534family make up this object. The electronic part is mounted in the way of Surface Mount. With its 20pins, it is designed to work with most electronic flip flops. Its clock edge trigger type is Positive Edge. There are 8bits in its design. Despite its superior flexibility, it relies on 8 circuits to achieve it. If high efficiency is desired, the supply voltage should be kept at 5V. To operate, the chip has a total of 3 output lines. The number of input lines is 8. In this case, the high level output current is set to -2.6mA. The low level output current is set to 24mA. The operating temperature should be lower than 70°C. Ideally, the operating temperature should be greater than 0°C. The minimum voltage required for operation is 4.5V. It is capable of supporting a maximum supply voltage of 5.5V. It is possible to achieve 35MHz frequencies.

DM74ALS534WM Features

Tube package
74ALS series
20 pins
8 Bits

DM74ALS534WM Applications

There are a lot of ON Semiconductor DM74ALS534WM Flip Flops applications.

• Divide a clock signal by 2 or 4
• Frequency Divider circuits
• Automotive
• Common Clocks
• Power down protection
• Event Detectors
• Frequency division
• High Performance Logic for test systems
• Differential Individual
• Shift registers