DM74ALS534WMX

DM74ALS534WMX Overview

The flip flop is packaged in 20-SOIC (0.295, 7.50mm Width). It is contained within the Tape & Reel (TR)package. The output it is configured with uses Tri-State, Inverted. In the configuration of the trigger, Positive Edgeis used. There is an electronic component mounted in the way of Surface Mount. A voltage of 4.5V~5.5Vis required for its operation. 0°C~70°C TAis the operating temperature. The type of this D latch is D-Type. It is a type of FPGA belonging to the 74ALS series. This D flip flop should not have a frequency greater than 35MHz. The list contains 1 elements. It consumes 19mA of quiescent Members of the 74ALS534family make up this object. In this case, the electronic component is mounted in the way of Surface Mount. Basically, it is designed with a set of 20 pins. This device has the clock edge trigger type of Positive Edge. This flip flop is designed with 8 Bits. To achieve this superior flexibility, 8 circuits are used. A high level of efficiency can be achieved by maintaining the supply voltage at 5V. It has 3 output lines to operate. It is reported that there are 8 input lines. -2.6mAis set as the high level output current. It is set to 24mAfor the low level output current. The operating temperature should be lower than 70°C. Ideally, the operating temperature should be higher than 0°C. The system operates with a minimum supply voltage of 4.5V. In this case, it supports a maximum supply voltage of 5.5V. We are able to achieve a frequency of 35MHz.

DM74ALS534WMX Features

Tape & Reel (TR) package
74ALS series
20 pins
8 Bits

DM74ALS534WMX Applications

There are a lot of ON Semiconductor DM74ALS534WMX Flip Flops applications.

• Dynamic threshold performance
• CMOS Process
• Single Down Count-Control Line
• Latch
• Parallel data storage
• Registers
• Bounce elimination switch
• Patented noise
• ESD performance
• Frequency Divider circuits