DM74ALS564AN

DM74ALS564AN Overview

The package is in the form of 20-DIP (0.300, 7.62mm). Package Tubeembeds it. It is configured with Tri-State, Non-Invertedas an output. This trigger uses the value Positive Edge. The electronic part is mounted in the way of Through Hole. A voltage of 4.5V~5.5Vis used as the supply voltage. In this case, the operating temperature is 0°C~70°C TA. It belongs to the type D-Typeof flip flops. It belongs to the 74ALSseries of FPGAs. A frequency of 30MHzshould not be exceeded by its output. A total of 1elements are contained within it. There is 18mA quiescent consumption. It is a member of the 74ALS564 family. Through Hole mounts this electronic component. As you can see from the design, it has pins with 20. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. It is designed with 8bits. The superior flexibility is achieved through the use of 8 circuits. For high efficiency, the supply voltage should be kept at 5V. It operates with 3 output lines. This input has 8lines in it. High level output current is set to -2.6mA. A 24mAvalue is set for low-level output current. Ideally, the operating temperature should be lower than 70°C. If the operating temperature is higher than 0°C, the system should operate properly. In order for it to operate, a supply voltage of 4.5Vis required. 5.5Vis the maximum supply voltage it supports. We are able to achieve a frequency of 30MHz.

DM74ALS564AN Features

Tube package
74ALS series
20 pins
8 Bits

DM74ALS564AN Applications

There are a lot of ON Semiconductor DM74ALS564AN Flip Flops applications.

• Automotive
• Latch
• ESD protection
• Functionally equivalent to the MC10/100EL29
• Clock pulse
• ESD performance
• Balanced Propagation Delays
• Asynchronous counter
• Storage registers
• Shift Registers