DM74AS574N

DM74AS574N Overview

It is packaged in the way of 20-DIP (0.300, 7.62mm). D flip flop is included in the Tubepackage. The output it is configured with uses Tri-State, Non-Inverted. Positive Edgeis the trigger it is configured with. Through Holeis positioned in the way of this electronic part. A voltage of 4.5V~5.5Vis required for its operation. It is operating at a temperature of 0°C~70°C TA. There is D-Type type of electronic flip flop associated with this device. The 74ASseries comprises this type of FPGA. It should not exceed 80MHzin its output frequency. A total of 1elements are contained within it. There is 116mA quiescent consumption. You can search similar parts based on 74AS574. Electronic part Through Holeis mounted in the way. This board is designed with 20pins on it. There is a clock edge trigger type of Positive Edgeon this device. There are 8bits in its design. Its flexibility is enhanced by 8 circuits. High efficiency requires the supply voltage to be maintained at 5V. The JK flip flop is with 3 output lines to operate. The number of input lines is 8. In this case, the high level output current is set to -15mA. 48mAis set as the low level output current. If the operating temperature is lower than 70°C, it is recommended. It is recommended that the operating temperature be greater than 0°C. The minimal supply voltage is 4.5V. There is a maximum voltage support of 5.5V. This frequency can be achieved at 80MHz.

DM74AS574N Features

Tube package
74AS series
20 pins
8 Bits

DM74AS574N Applications

There are a lot of ON Semiconductor DM74AS574N Flip Flops applications.

• Buffer registers
• Single Up Count-Control Line
• Instrumentation
• Pattern generators
• Load Control
• Memory
• Balanced 24 mA output drivers
• Asynchronous counter
• EMI reduction circuitry
• Circuit Design