LM809M3X-3.08/NOPB

LM809M3X-3.08/NOPB Overview

This power management consists of 3 mounting terminals on which it can be mounted. It is packaged with Tape & Reel (TR). Power management is possible to find a series of 1 functions. It is possible to find on this power management a series of 1 channels. In this PMIC, you can find TO-236-3, SC-59, SOT-23-3 functions for your reference. There are a lot of similarities between this IC power and other Simple Reset/Power-On Reset products. There is a specification for the peak reflow temperature of the package to be 260. Manage ics operate at 3.3V supply voltages. In a 1 supply voltage, the PMIC chip conducts. Surface Mount is the one that mounts power management. In this case, this PMIC chip can be sub-categorized as a Power Management Circuits chip. In total, the power management has 3 pins in it. 3 pins make up the power management. It is recommended that the minimum supply voltage (Vsup) for this IC management should not be less than 1V volts. The supply voltage (Vsup) should not exceed 5.5V volts in this IC power. Surface Mount is the recommended mounting type. The temperature of the supervisors should be set to this range: -40°C~105°C TA. There is an output voltage of Push-Pull, Totem Pole from this supervisor when it is operating. As far as the supply current of the power management is concerned, it is 15μA. It is always advisable to use LM809, the base supervisor number, when searching for similar PMICs from the manufacturer.

LM809M3X-3.08/NOPB Features

Simple Reset/Power-On Reset type
Minimum supply voltage of 1V
15μA operating supply current

LM809M3X-3.08/NOPB Applications

There are a lot of Texas Instruments LM809M3X-3.08/NOPB Voltage Supervisors applications.

• Smart meter
• Utility meter
• Electronics installed in the vehicle
• Detection of phase imbalance
• Detection of phase loss
• DSP
• Microprocessor system
• Dash board
• Unattended substation automation
• DVR