M74HC174TTR

M74HC174TTR Overview

The item is packaged in 16-TSSOP (0.173, 4.40mm Width)cases. It is included in the package Tape & Reel (TR). In the configuration, Non-Invertedis used as the output. It is configured with a trigger that uses a value of Positive Edge. This electronic part is mounted in the way of Surface Mount. A voltage of 2V~6Vis required for its operation. In the operating environment, the temperature is -55°C~125°C TA. This logic flip flop is classified as type D-Type. FPGAs belonging to the 74HCseries contain this type of chip. Its output frequency should not exceed 66MHz Hz. A total of 1elements are present in it. This process consumes 4μA quiescents. There have been 16 terminations. Members of the M74HC174family make up this object. A voltage of 4.5V is used to power it. The input capacitance of this T flip flop is 5pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. Devices in the HC/UHfamily are electronic devices. Electronic part Surface Mountis mounted in the way. As you can see from the design, it has pins with 16. A Positive Edgeclock edge trigger is used in this device. The part you are looking for is included in FF/Latches. There are 6bits in this flip flop. Vsup reaches 6V, the maximal supply voltage. Normal operation requires a supply voltage (Vsup) above 2V. Its superior flexibility is attributed to its use of 7 circuits. In light of its reliable performance, this T flip flop is well suited for TAPE AND REEL. It has 6 output lines to operate.

M74HC174TTR Features

Tape & Reel (TR) package
74HC series
16 pins
6 Bits

M74HC174TTR Applications

There are a lot of STMicroelectronics M74HC174TTR Flip Flops applications.

• CMOS Process
• Counters
• Data storage
• Individual Asynchronous Resets
• Storage registers
• Asynchronous counter
• Parallel data storage
• Communications
• Divide a clock signal by 2 or 4
• Latch