M74HC533B1R

M74HC533B1R Overview

In the package 20-DIP (0.300, 7.62mm), it can be found. Packaged in the way of Tube. It uses Tri-State as the output. D-Type Transparent Latch is the logic type of this electrical device. Through Hole is used to mount this electronic part. It operates at a voltage of 2V~6V. It is -55°C~125°C at the operating temperature. The 74HC series contains FPGAs of this type. 8 Bits are used in the design of this electronic part. In this device, there are 20 terminations. There is no doubt that it belongs to the family M74HC53. In order to operate it, the supply voltage must be 4.5V. 20 pins are available on it. This electronic device belongs to the family of HC/UH. It is designed with 20 pins. Mounting this electronic component follows the Through Hole method. 2 ports are available on this device. FF/Latches is the subcategory of this part. It reaches 6V when the supply voltage (Vsup) reaches maximum. A total of 2/6V power supplies are needed to run it. It is recommended that the supply voltage (Vsup) be greater than 2V. It consists of 8 input lines from which an electronic circuit can be built. There are 3 output Lines, which generate the binary equivalent of the input line whose value is equal to “1” and are available to encode either a decimal or hexadecimal input pattern to typically a binary or “B. C. D” (binary coded decimal) output code.

M74HC533B1R Features

20-DIP (0.300, 7.62mm) package
74HC series
8 Bits
M74HC53 family
20 pin count
20 pins
2/6V power supplies

M74HC533B1R Applications

There are a lot of STMicroelectronics M74HC533B1R Latches applications.

• Pattern generators
• Shift Registers
• Serial Output Register
• Control circuits
• Parallel Output
• Relay
• Decade counting
• Decade counting 7-segment decimal display
• Accumulator Registers
• BCD counting