M74HC76M1R

M74HC76M1R Overview

The item is packaged in 16-SOIC (0.154, 3.90mm Width)cases. A package named Tape & Reel (TR)includes it. T flip flop uses Differentialas the output. The trigger it is configured with uses Negative Edge. The electronic part is mounted in the way of Surface Mount. It operates with a supply voltage of 2V~6V. A temperature of -55°C~125°C TAis considered to be the operating temperature. This D latch has the type JK Type. JK flip flop is a part of the 74HCseries of FPGAs. Its output frequency should not exceed 67MHz Hz. Despite external influences, it consumes 2μAof quiescent current. A total of 16 terminations have been made. If you search by M74HC76, you will find similar parts. Power is provided by a 4.5V supply. The input capacitance of this T flip flop is 5pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. Electronic devices of this type belong to the HC/UHfamily. There is an electronic part mounted in the way of Surface Mount. This board is designed with 16pins on it. A Negative Edgeclock edge trigger is used in this device. It is included in FF/Latches. It reaches 6Vwhen the supply voltage is maximal (Vsup). The supply voltage (Vsup) should be kept above 2V for normal operation. As a result of its reliability, this D flip flop is ideally suited for TUBE. As of now, there are 2input lines. As an additional reference, you may refer to electronic flip flop MASTER SLAVE OPERATION.

M74HC76M1R Features

Tape & Reel (TR) package
74HC series
16 pins

M74HC76M1R Applications

There are a lot of STMicroelectronics M74HC76M1R Flip Flops applications.

• Shift registers
• Dynamic threshold performance
• Event Detectors
• Pattern generators
• Automotive
• Functionally equivalent to the MC10/100EL29
• ESD performance
• Data Synchronizers
• Bus hold
• Control circuits