M74HCT374M1R

M74HCT374M1R Overview

It is packaged in the way of 20-SOIC (0.295, 7.50mm Width). You can find it in the Tape & Reel (TR)package. As configured, the output uses Tri-State, Non-Inverted. JK flip flop uses Positive Edgeas the trigger. Surface Mountis positioned in the way of this electronic part. The JK flip flop operates at 4.5V~5.5Vvolts. Currently, the operating temperature is -55°C~125°C TA. This electronic flip flop is of type D-Type. In FPGA terms, D flip flop is a type of 74HCTseries FPGA. It should not exceed 50MHzin terms of its output frequency. The list contains 1 elements. There is 4μA quiescent consumption. It has been determined that there have been 20 terminations. The M74HCT374 family contains it. A voltage of 5V is used to power it. A JK flip flop with a 5pFfarad input capacitance is used here. A device of this type belongs to the family of HCT. The electronic part is mounted in the way of Surface Mount. 20pins are included in its design. This device has Positive Edgeas its clock edge trigger type. The part is included in FF/Latches. This flip flop is designed with 8 Bits. As soon as 5.5Vis reached, Vsup reaches its maximum value. Normally, the supply voltage (Vsup) should be kept above 4.5V. Using 8 circuits, it is highly flexible. In view of its reliability, this D flip flop is a good fit for TUBE. An electrical current of 5V volts is applied to it. The flip flop has 2embedded ports. There are 3 output lines in this JK flip flop.

M74HCT374M1R Features

Tape & Reel (TR) package
74HCT series
20 pins
8 Bits
5V power supplies

M74HCT374M1R Applications

There are a lot of STMicroelectronics M74HCT374M1R Flip Flops applications.

• Data Synchronizers
• Supports Live Insertion
• Counters
• Circuit Design
• Test & Measurement
• Common Clocks
• Storage Registers
• Divide a clock signal by 2 or 4
• Functionally equivalent to the MC10/100EL29
• Computers