MAX17500AAUB+T

MAX17500AAUB+T Overview

As a result of 10-TFSOP, 10-MSOP (0.118, 3.00mm Width) compact design, the switching controller is compatible with most applications. There is sufficient capacity to generate switching controller for outputs 1. An enclosure of Tape & Reel (TR) is used to package the PMIC. A total of Transistor Driver dc switching's outputs can be handled by it. A 23.6V~30V voltage is supplied to the dc control and used for operating it. Suitable for working in an dc switcher that has a -40°C~125°C TJ. With this switching controller, you can switch at 50kHz~2.5MHz. It is suitable for general dc dc regulator when it is set to Surface Mount. DCDC regulator is controlled efficiently by Enable. Switch converters are connected to ICs with SWITCHING CONTROLLER analog outputs. You can find other relevant dc to dc converter ics by searching "MAX17500". There are 10 pins on switching converter. As determined by the test statistics, the output voltage of DC regulator is 1.5V. A starting point for a project is to note down the dc dc regulator's usual output current, which is 50μA. It is set to 50 % duty cycle to ensure voltage regulator dc to dc reliability during power-ups and power-downs. Because of DC switcher's Surface Mount, it is suitable for most prototype designs and applications. It is estimated that this dc regulatorhas a maximum frequency of 625kHz. It is suggested that users apply 24V to the voltage regulator dc to dc in order to run it safely and reliably in a circuit. It runs on a supply current of 50μA.

MAX17500AAUB+T Features

Transistor Driver Outputs
Switching Frequency: 50kHz~2.5MHz
Enable
Max Duty Cycle: 50 %

MAX17500AAUB+T Applications

There are a lot of Maxim Integrated MAX17500AAUB+T DC to DC converter applications.

• Computer application technology
• Servo drive system
• Thermal power
• Laboratories
• Network technology
• Flaw detection equipment
• ATMs
• Arc suppression circuits
• Overvoltage protection circuits in TV sets
• Power supplies of electronic gadgets