MC100E451FNR2G

MC100E451FNR2G Overview

It is packaged in the way of 28-LCC (J-Lead). It is included in the package Tape & Reel (TR). There is a Non-Invertedoutput configured with it. This trigger is configured to use Positive Edge. There is an electric part mounted in the way of Surface Mount. The JK flip flop operates at -4.2V~-5.7Vvolts. A temperature of 0°C~85°C TAis used in the operation. Logic flip flops of this type are classified as D-Type. In this case, it is a type of FPGA belonging to the 100E series. Its output frequency should not exceed 1.1GHz Hz. D latch consists of 1 elements. It consumes 101mA of quiescent The number of terminations is 28. JK flip flop belongs to 100E451 family. Power is supplied from a voltage of 5V volts. A part of the electronic system is mounted in the way of Surface Mount. There are 28pins on it. This device has Positive Edgeas its clock edge trigger type. It is part of the FF/Latchesbase part number family. There is a 5.7Vmaximum supply voltage (Vsup). To achieve this superior flexibility, 2 circuits are used. In view of its reliability, this D flip flop is a good fit for TAPE AND REEL. A power supply of -4.5Vis required to operate it. 50mA is set as the high level output current. There is 50mA output current at the low level.

MC100E451FNR2G Features

Tape & Reel (TR) package
100E series
28 pins
-4.5V power supplies

MC100E451FNR2G Applications

There are a lot of ON Semiconductor MC100E451FNR2G Flip Flops applications.

• Divide a clock signal by 2 or 4
• Event Detectors
• Buffered Clock
• Shift Registers
• ATE
• Convert a momentary switch to a toggle switch
• Memory
• CMOS Process
• Asynchronous counter
• 2 – Bit synchronous counter