MC100EL30DWR2G

MC100EL30DWR2G Overview

It is packaged in the way of 20-SOIC (0.295, 7.50mm Width). It is contained within the Tape & Reel (TR)package. T flip flop uses Differentialas the output. It is configured with a trigger that uses a value of Positive Edge. It is mounted in the way of Surface Mount. A supply voltage of -4.2V~-5.7V is required for operation. -40°C~85°C TAis the operating temperature. D-Typedescribes this flip flop. In this case, it is a type of FPGA belonging to the 100EL series. A frequency of 1.2GHzshould be the maximum output frequency. It consumes 62mA of quiescent current without being affected by external factors. There are 20 terminations,The 100EL30 family contains this object. A voltage of 5V provides power to the D latch. The electronic part is mounted in the way of Surface Mount. This board has 20 pins. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. This part is included in FF/Latches. 5.7Vis the maximum supply voltage (Vsup). If you want to maintain normal operation, you should keep the supply voltage (Vsup) above 4.2V. 3 circuits are used to achieve its superior flexibility. As a result of its reliable performance, this T flip flop is suitable for TAPE AND REEL. The D latch runs on a voltage of -4.5V volts. Additionally, you may refer to the additional NECL MODE: VCC = 0V WITH VEE = -4.2V TO -5.7V of the electronic flip flop. The high level output current is set to 50mA. There is no low level output current set at 50mA.

MC100EL30DWR2G Features

Tape & Reel (TR) package
100EL series
20 pins
-4.5V power supplies

MC100EL30DWR2G Applications

There are a lot of ON Semiconductor MC100EL30DWR2G Flip Flops applications.

• EMI reduction circuitry
• Frequency division
• Parallel data storage
• Control circuits
• Set-reset capability
• Data storage
• Divide a clock signal by 2 or 4
• Pattern generators
• Registers
• Automotive