MC100EL31DR2G

MC100EL31DR2G Overview

In the form of 8-SOIC (0.154, 3.90mm Width), it has been packaged. The Tape & Reel (TR)package contains it. It is configured with Differentialas an output. The trigger it is configured with uses Positive Edge. The electronic part is mounted in the way of Surface Mount. Powered by a -4.2V~-5.7Vvolt supply, it operates as follows. The operating temperature is -40°C~85°C TA. A flip flop of this type is classified as a D-Type. In terms of FPGAs, it belongs to the 100EL series. Its output frequency should not exceed 2.8GHz. It consumes 32mA of quiescent The number of terminations is 8. The 100EL31family includes it. A voltage of 5V is used as the power supply for this D latch. This electronic part is mounted in the way of Surface Mount. It is designed with 8 pins. In this device, the clock edge trigger type is Positive Edge. It is included in FF/Latches. It is designed with a number of bits of 1. It reaches 5.7Vwhen the supply voltage is maximal (Vsup). Normally, the supply voltage (Vsup) should be kept above 4.2V. The superior flexibility is achieved through the use of 1 circuits. In light of its reliable performance, this T flip flop is well suited for TAPE AND REEL. A total of -4.5V power supplies are needed to run it. Additionally, you may refer to the additional NECL MODE: VCC = 0V WITH VEE = -4.2V TO -5.7V of the electronic flip flop. High level output current is set to 50mA. There is no low level output current set at 50mA.

MC100EL31DR2G Features

Tape & Reel (TR) package
100EL series
8 pins
1 Bits
-4.5V power supplies

MC100EL31DR2G Applications

There are a lot of ON Semiconductor MC100EL31DR2G Flip Flops applications.

• Frequency division
• Buffer registers
• Functionally equivalent to the MC10/100EL29
• ESCC
• Registers
• Control circuits
• Modulo – n – counter
• Individual Asynchronous Resets
• Digital electronics systems
• Circuit Design