MC100EL35DTR2

MC100EL35DTR2 Overview

The package is in the form of 8-TSSOP, 8-MSOP (0.118, 3.00mm Width). The Tape & Reel (TR)package contains it. T flip flop uses Differentialas the output. Positive Edgeis the trigger it is configured with. There is an electric part mounted in the way of Surface Mount. The supply voltage is set to -4.2V~-5.7V. In this case, the operating temperature is -40°C~85°C TA. This electronic flip flop is of type D-Type. This type of FPGA is a part of the 100EL series. A frequency of 2.2GHzshould not be exceeded by its output. As a result, it consumes 32mA quiescent current and is not affected by external forces. 8terminations have occurred. This D latch belongs to the family of 100EL35. It is powered from a supply voltage of 5V. This electronic part is mounted in the way of Surface Mount. This device exhibits a clock edge trigger type of Positive Edge. The RS flip flops belongs to FF/Latches base part number. An electronic part designed with 2bits is used in this application. In this case, the maximum supply voltage (Vsup) reaches 5.7V. For normal operation, the supply voltage (Vsup) should be kept above 4.2V. Due to its superior flexibility, it uses 1 circuits. In view of its reliability, this D flip flop is a good fit for TAPE AND REEL. The system runs on a power supply of +-5V watts. Additionally, you may refer to the additional NECL MODE: VCC = 0V WITH VEE = -4.2V TO -5.7V of the electronic flip flop.

MC100EL35DTR2 Features

Tape & Reel (TR) package
100EL series
2 Bits
+-5V power supplies

MC100EL35DTR2 Applications

There are a lot of ON Semiconductor MC100EL35DTR2 Flip Flops applications.

• Buffered Clock
• High Performance Logic for test systems
• Clock pulse
• Individual Asynchronous Resets
• Load Control
• Frequency Divider circuits
• Communications
• Data transfer
• Bus hold
• Computing