MC100EL51DTG

MC100EL51DTG Overview

As a result, it is packaged as 8-TSSOP, 8-MSOP (0.118, 3.00mm Width). It is included in the package Tube. In the configuration, Differentialis used as the output. This trigger is configured to use Positive, Negative. There is an electronic component mounted in the way of Surface Mount. Powered by a -4.2V~-5.7Vvolt supply, it operates as follows. Temperature is set to -40°C~85°C TA. There is D-Type type of electronic flip flop associated with this device. JK flip flop is a part of the 100ELseries of FPGAs. There should be no greater frequency than 2.8GHzon its output. It consumes 29mA of quiescent There have been 8 terminations. D latch belongs to the 100EL51 family. It is powered from a supply voltage of 5V. It is mounted in the way of Surface Mount. This board has 8 pins. This device has Positive Edgeas its clock edge trigger type. This part is included in FF/Latches. An electronic part with 1bits has been designed. It reaches 5.7Vwhen the maximum supply voltage (Vsup) is applied. A normal operating voltage (Vsup) should remain above 4.2V. Using 1 circuits, it is highly flexible. Compared to other similar T flip flops, this device offers reliable performance and is well suited for RAIL. An electrical current of -4.5V volts is applied to it. Its output current of 50mAallows for maximum design flexibility. Additionally, it is characterized by NECL MODE: VCC = 0V WITH VEE = -4.2V TO -5.7V.

MC100EL51DTG Features

Tube package
100EL series
8 pins
1 Bits
-4.5V power supplies

MC100EL51DTG Applications

There are a lot of ON Semiconductor MC100EL51DTG Flip Flops applications.

• CMOS Process
• Cold spare funcion
• Storage Registers
• Latch-up performance
• Convert a momentary switch to a toggle switch
• Clock pulse
• Single Down Count-Control Line
• ESD protection
• Differential Individual
• Storage registers