MC100EL51DTR2

MC100EL51DTR2 Overview

The item is packaged in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width)cases. It is included in the package Tape & Reel (TR). Differentialis the output configured for it. The trigger it is configured with uses Positive, Negative. This electronic part is mounted in the way of Surface Mount. A voltage of -4.2V~-5.7Vis used as the supply voltage. It is at -40°C~85°C TAdegrees Celsius that the system is operating. This electronic flip flop is of type D-Type. FPGAs belonging to the 100ELseries contain this type of chip. It should not exceed 2.8GHzin its output frequency. T flip flop consumes 29mA quiescent energy. There have been 8 terminations. D latch belongs to the 100EL51 family. A voltage of 5V provides power to the D latch. This electronic part is mounted in the way of Surface Mount. This device's clock edge trigger type is Positive Edge. The part is included in FF/Latches. 1bits are used in its design. It reaches 5.7Vwhen the supply voltage is maximal (Vsup). Normally, the supply voltage (Vsup) should be kept above 4.2V. 1 circuits are used to achieve its superior flexibility. A reliable performance of this D flip flop makes it well suited for use in TAPE AND REEL. A power supply of -4.5Vis required to operate it. In addition, you can refer to the additinal NECL MODE: VCC = 0V WITH VEE = -4.2V TO -5.7V of the D latch.

MC100EL51DTR2 Features

Tape & Reel (TR) package
100EL series
1 Bits
-4.5V power supplies

MC100EL51DTR2 Applications

There are a lot of ON Semiconductor MC100EL51DTR2 Flip Flops applications.

• Instrumentation
• Common Clocks
• Safety Clamp
• Bus hold
• Single Up Count-Control Line
• Asynchronous counter
• Count Modes
• Clock pulse
• Reduced system switching noise
• Balanced Propagation Delays