MC100EL52D

MC100EL52D Overview

The flip flop is packaged in a case of 8-SOIC (0.154, 3.90mm Width). It is contained within the Tubepackage. It is configured with Differentialas an output. There is a trigger configured with Positive, Negative. There is an electrical part that is mounted in the way of Surface Mount. The JK flip flop operates with an input voltage of -4.2V~-5.7V volts. It is operating at a temperature of -40°C~85°C TA. D-Typeis the type of this D latch. In this case, it is a type of FPGA belonging to the 100EL series. There should be no greater frequency than 2.8GHzon its output. There is 25mA quiescent consumption. There are 8 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. Members of the 100EL52family make up this object. A voltage of 5V provides power to the D latch. Surface Mount mounts this electronic component. 8pins are included in its design. This device exhibits a clock edge trigger type of Positive Edge. There is a FF/Latchesbase part number assigned to the RS flip flops. There are 1bits in this flip flop. The maximal supply voltage (Vsup) reaches 5.7V. The supply voltage (Vsup) should be maintained above 4.2V for normal operation. In order to achieve its superior flexibility, 1 circuits are used. As a result of its reliability, this D flip flop is ideally suited for RAIL. The D latch runs on a voltage of -4.5V volts. Additionally, it is characterized by NECL MODE: VCC = 0V WITH VEE = -4.2V TO -5.7V.

MC100EL52D Features

Tube package
100EL series
8 pins
1 Bits
-4.5V power supplies

MC100EL52D Applications

There are a lot of ON Semiconductor MC100EL52D Flip Flops applications.

• Control circuits
• Balanced 24 mA output drivers
• Clock pulse
• Buffered Clock
• Single Down Count-Control Line
• Parallel data storage
• Latch
• Test & Measurement
• Frequency Divider circuits
• Communications