MC100EP31DR2G

MC100EP31DR2G Overview

8-SOIC (0.154, 3.90mm Width)is the way it is packaged. You can find it in the Tape & Reel (TR)package. It is configured with Differentialas an output. The trigger configured with it uses Positive Edge. There is an electrical part that is mounted in the way of Surface Mount. A -3V~-5.5Vsupply voltage is required for it to operate. It is operating at -40°C~85°C TA. A flip flop of this type is classified as a D-Type. In this case, it is a type of FPGA belonging to the 100EP series. In order for it to function properly, its output frequency should not exceed 3GHz. During its operation, it consumes 45mA quiescent energy. It has been determined that there have been 8 terminations. If you search by 100EP31, you will find similar parts. A voltage of 3.3V is used to power it. There is an electronic part that is mounted in the way of Surface Mount. This board has 8 pins. This device has Positive Edgeas its clock edge trigger type. The RS flip flops belongs to FF/Latches base part number. An electronic part designed with 1bits is used in this application. In this case, the maximum supply voltage (Vsup) reaches 5.5V. Keeping the supply voltage (Vsup) above 3V is necessary for normal operation. The superior flexibility is achieved through the use of 1 circuits. As a result of its reliable performance, this T flip flop is suitable for TAPE AND REEL. The system runs on a power supply of -4.5V watts. There is also a characteristic of NECL MODE: VCC = 0V WITH VEE = -3.0V TO -5.5V.

MC100EP31DR2G Features

Tape & Reel (TR) package
100EP series
8 pins
1 Bits
-4.5V power supplies

MC100EP31DR2G Applications

There are a lot of ON Semiconductor MC100EP31DR2G Flip Flops applications.

• Data Synchronizers
• Memory
• Asynchronous counter
• Counters
• ATE
• Functionally equivalent to the MC10/100EL29
• Bus hold
• Divide a clock signal by 2 or 4
• Frequency Dividers
• Consumer