MC100EP31MNR4G

MC100EP31MNR4G Overview

8-VFDFN Exposed Padis the way it is packaged. A package named Tape & Reel (TR)includes it. As configured, the output uses Differential. This trigger is configured to use Positive Edge. There is an electric part mounted in the way of Surface Mount. A voltage of -3V~-5.5Vis required for its operation. It is operating at -40°C~85°C TA. It belongs to the type D-Typeof flip flops. In this case, it is a type of FPGA belonging to the 100EP series. You should not exceed 3GHzin its output frequency. There is 45mA quiescent consumption. Terminations are 8. The object belongs to the 100EP31 family. The power source is powered by 3.3V. It is mounted in the way of Surface Mount. As you can see from the design, it has pins with 8. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. This part is included in FF/Latches. An electronic part with 1bits has been designed. Vsup reaches its maximum value at 5.5V. Normally, the supply voltage (Vsup) should be above 3V. 1 circuits are used to achieve its superior flexibility. It runs on -4.5Vvolts of power. There is also a characteristic of NECL MODE: VCC = 0V WITH VEE = -3.0V TO -5.5V.

MC100EP31MNR4G Features

Tape & Reel (TR) package
100EP series
8 pins
1 Bits
-4.5V power supplies

MC100EP31MNR4G Applications

There are a lot of ON Semiconductor MC100EP31MNR4G Flip Flops applications.

• Test & Measurement
• Storage Registers
• Safety Clamp
• Individual Asynchronous Resets
• ATE
• Matched Rise and Fall
• Latch-up performance
• Frequency Dividers
• EMI reduction circuitry
• Circuit Design