MC100EP52DTR2G

MC100EP52DTR2G Overview

It is packaged in the way of 8-TSSOP, 8-MSOP (0.118, 3.00mm Width). Package Tape & Reel (TR)embeds it. In the configuration, Differentialis used as the output. This trigger is configured to use Positive, Negative. In this case, the electronic component is mounted in the way of Surface Mount. It operates with a supply voltage of -3V~-5.5V. It is operating at -40°C~85°C TA. It is an electronic flip flop with the type D-Type. This type of FPGA is a part of the 100EP series. You should not exceed 3GHzin the output frequency of the device. It consumes 45mA of quiescent It has been determined that there have been 8 terminations. D latch belongs to the 100EP52 family. A voltage of 3.3V is used as the power supply for this D latch. The electronic part is mounted in the way of Surface Mount. Basically, it is designed with a set of 8 pins. This device has the clock edge trigger type of Positive Edge. This RS flip flops is a part number FF/Latches. This flip flop is designed with 1 Bits. 5.5Vis the maximum supply voltage (Vsup). The supply voltage (Vsup) should be kept above 3V for normal operation. In order to achieve its superior flexibility, 1 circuits are used. Considering its reliability, this T flip flop is well suited for TAPE AND REEL. In order for the device to operate, it requires -4.5V power supplies. The output current of 50mA makes it feature maximum design flexibility. Additionally, you may refer to the D latch's additional NECL MODE: VCC = 0V WITH VEE = -3V TO -5.5V. -50mA is set as the high level output current. 50mA is the low level output current.

MC100EP52DTR2G Features

Tape & Reel (TR) package
100EP series
8 pins
1 Bits
-4.5V power supplies

MC100EP52DTR2G Applications

There are a lot of ON Semiconductor MC100EP52DTR2G Flip Flops applications.

• Frequency division
• Buffer registers
• Registers
• Circuit Design
• Pattern generators
• Computing
• ESCC
• Matched Rise and Fall
• Common Clocks
• Computers