MC100EP52MNR4G

MC100EP52MNR4G Overview

It is packaged in the way of 8-VFDFN Exposed Pad. Package Tape & Reel (TR)embeds it. Differentialis the output configured for it. It is configured with a trigger that uses a value of Positive, Negative. Surface Mountmounts this electrical part. The JK flip flop operates at a voltage of -3V~-5.5V. It is at -40°C~85°C TAdegrees Celsius that the system is operating. A flip flop of this type is classified as a D-Type. In FPGA terms, D flip flop is a type of 100EPseries FPGA. You should not exceed 3GHzin the output frequency of the device. There is 45mA quiescent consumption. A total of 8 terminations have been made. The 100EP52 family contains it. The D flip flop is powered by a voltage of 3.3V . A part of the electronic system is mounted in the way of Surface Mount. As you can see from the design, it has pins with 8. Its clock edge trigger type is Positive Edge. This device has the base part number FF/Latches. This flip flop is designed with 1 Bits. In this case, the maximum supply voltage (Vsup) reaches 5.5V. For normal operation, the supply voltage (Vsup) should be kept above 3V. 1 circuits are used to achieve its superior flexibility. Considering its reliability, this T flip flop is well suited for TAPE AND REEL. It operates from -4.5V power supplies. With a current output of 50mA , it offers maximum design flexibility. As an additional reference, you may refer to electronic flip flop NECL MODE: VCC = 0V WITH VEE = -3V TO -5.5V. A -50mAis set for the high level output current. In the low level output current setting, 50mAis used.

MC100EP52MNR4G Features

Tape & Reel (TR) package
100EP series
8 pins
1 Bits
-4.5V power supplies

MC100EP52MNR4G Applications

There are a lot of ON Semiconductor MC100EP52MNR4G Flip Flops applications.

• Frequency division
• 2 – Bit synchronous counter
• Bounce elimination switch
• Functionally equivalent to the MC10/100EL29
• Bus hold
• Memory
• Load Control
• Test & Measurement
• Balanced Propagation Delays
• Frequency Dividers