MC10EL35DG

MC10EL35DG Overview

The item is packaged in 8-SOIC (0.154, 3.90mm Width)cases. A package named Tubeincludes it. In the configuration, Differentialis used as the output. It is configured with a trigger that uses a value of Positive Edge. Surface Mountis in the way of this electric part. A voltage of -4.2V~-5.7Vis used as the supply voltage. The operating temperature is -40°C~85°C TA. Logic flip flops of this type are classified as D-Type. It belongs to the 10ELseries of FPGAs. Its output frequency should not exceed 2.2GHz Hz. As a result, it consumes 32mA quiescent current. 8terminations have occurred. This D latch belongs to the family of 10EL35. Power is provided by a 5V supply. It is mounted in the way of Surface Mount. The electronic flip flop is designed with pins 8. Its clock edge trigger type is Positive Edge. The part you are looking for is included in FF/Latches. There are 2bits in this flip flop. It reaches 5.7Vwhen the maximum supply voltage (Vsup) is applied. For normal operation, the supply voltage (Vsup) should be kept above 4.2V. Its superior flexibility is attributed to its use of 1 circuits. In light of its reliable performance, this T flip flop is well suited for RAIL. A total of -5.2V power supplies are needed to run it. This T flip flop features a maximum design flexibility due to its output current of 50mA. Additionally, you may refer to the additional NECL MODE: VCC = 0V WITH VEE = -4.2V TO -5.7V of the electronic flip flop. A high level output current of 50mAis set. In the low level output current setting, 50mAis used.

MC10EL35DG Features

Tube package
10EL series
8 pins
2 Bits
-5.2V power supplies

MC10EL35DG Applications

There are a lot of ON Semiconductor MC10EL35DG Flip Flops applications.

• Latch-up performance
• Control circuits
• Communications
• Digital electronics systems
• Computers
• Frequency division
• Count Modes
• High Performance Logic for test systems
• Event Detectors
• Individual Asynchronous Resets