MC10EL35DR2

MC10EL35DR2 Overview

The package is in the form of 8-SOIC (0.154, 3.90mm Width). Package Tape & Reel (TR)embeds it. It is configured with Differentialas an output. It is configured with a trigger that uses Positive Edge. It is mounted in the way of Surface Mount. A voltage of -4.2V~-5.7Vis required for its operation. It is at -40°C~85°C TAdegrees Celsius that the system is operating. A flip flop of this type is classified as a D-Type. In terms of FPGAs, it belongs to the 10EL series. You should not exceed 2.2GHzin the output frequency of the device. As a result, it consumes 32mA quiescent current and is not affected by external forces. In 8terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. If you search by 10EL35, you will find similar parts. Power is provided by a 5V supply. This electronic part is mounted in the way of Surface Mount. Basically, it is designed with a set of 8 pins. A Positive Edgeclock edge trigger is used in this device. The part is included in FF/Latches. It is designed with a number of bits of 2. Vsup reaches its maximum value at 5.7V. Normally, the supply voltage (Vsup) should be kept above 4.2V. 1 circuits are used to achieve its superior flexibility. In light of its reliable performance, this T flip flop is well suited for TAPE AND REEL. The D latch runs on a voltage of -5.2V volts. Additionally, you may refer to the D latch's additional NECL MODE: VCC = 0V WITH VEE = -4.2V TO -5.7V.

MC10EL35DR2 Features

Tape & Reel (TR) package
10EL series
8 pins
2 Bits
-5.2V power supplies

MC10EL35DR2 Applications

There are a lot of ON Semiconductor MC10EL35DR2 Flip Flops applications.

• Circuit Design
• ESD protection
• Storage Registers
• Instrumentation
• Shift Registers
• ESCC
• Patented noise
• Consumer
• Computers
• Latch-up performance