MC10EL35DTR2G

MC10EL35DTR2G Overview

It is embeded in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) case. There is an embedded version in the package Tape & Reel (TR). Currently, the output is configured to use Differential. This trigger is configured to use Positive Edge. Surface Mountis occupied by this electronic component. The supply voltage is set to -4.2V~-5.7V. It is operating at a temperature of -40°C~85°C TA. Logic flip flops of this type are classified as D-Type. In FPGA terms, D flip flop is a type of 10ELseries FPGA. This D flip flop should not have a frequency greater than 2.2GHz. It consumes 32mA of quiescent A total of 8terminations have been recorded. The 10EL35 family contains this object. An input voltage of 5Vpowers the D latch. Surface Mount mounts this electronic component. As you can see from the design, it has pins with 8. This device has Positive Edgeas its clock edge trigger type. It is included in FF/Latches. An electronic part with 2bits has been designed. Vsup reaches 5.7V, the maximal supply voltage. It is imperative that the supply voltage (Vsup) is maintained above 4.2Vin order to ensure normal operation. The superior flexibility is achieved through the use of 1 circuits. As a result of its reliability, this D flip flop is ideally suited for TAPE AND REEL. The power supply is -5.2V. In addition, NECL MODE: VCC = 0V WITH VEE = -4.2V TO -5.7Vis a characteristic of it.

MC10EL35DTR2G Features

Tape & Reel (TR) package
10EL series
8 pins
2 Bits
-5.2V power supplies

MC10EL35DTR2G Applications

There are a lot of ON Semiconductor MC10EL35DTR2G Flip Flops applications.

• Safety Clamp
• Computing
• Asynchronous counter
• Event Detectors
• Dynamic threshold performance
• Buffer registers
• Parallel data storage
• Communications
• ESCC
• Frequency Divider circuits