MC10EL51DG

MC10EL51DG Overview

8-SOIC (0.154, 3.90mm Width)is the packaging method. It is included in the package Tube. T flip flop is configured with an output of Differential. It is configured with a trigger that uses a value of Positive, Negative. Surface Mountis occupied by this electronic component. A supply voltage of -4.2V~-5.7V is required for operation. In the operating environment, the temperature is -40°C~85°C TA. D-Typedescribes this flip flop. In terms of FPGAs, it belongs to the 10EL series. In order for it to function properly, its output frequency should not exceed 2.8GHz. As a result, it consumes 29mA of quiescent current without being affected by external factors. There have been 8 terminations. JK flip flop belongs to 10EL51 family. It is powered from a supply voltage of 5V. A part of the electronic system is mounted in the way of Surface Mount. This board has 8 pins. It has a clock edge trigger type of Positive Edge. There is a FF/Latchesbase part number assigned to the RS flip flops. 1bits are used in its design. 5.7Vis the maximum supply voltage (Vsup). For normal operation, the supply voltage (Vsup) should be kept above 4.2V. To achieve this superior flexibility, 1 circuits are used. In view of its reliability, this D flip flop is a good fit for RAIL. A total of -5.2V power supplies are needed to run it. With an output current of 50mA, it is possible to design the device in any way you want. Additionally, there are NECL MODE: VCC = 0V WITH VEE = -4.2V TO -5.7V on the electronic flip flop that can be referred to. 50mAis the output current at high level. In the low level output current setting, 50mAis used.

MC10EL51DG Features

Tube package
10EL series
8 pins
1 Bits
-5.2V power supplies

MC10EL51DG Applications

There are a lot of ON Semiconductor MC10EL51DG Flip Flops applications.

• Pattern generators
• Patented noise
• Shift Registers
• Frequency Dividers
• Latch
• Event Detectors
• Bus hold
• Balanced Propagation Delays
• Data storage
• Cold spare funcion