MC10EL51DTG

MC10EL51DTG Overview

It is packaged in the way of 8-TSSOP, 8-MSOP (0.118, 3.00mm Width). The Tubepackage contains it. There is a Differentialoutput configured with it. Positive, Negativeis the trigger it is configured with. Surface Mountmounts this electrical part. With a supply voltage of -4.2V~-5.7V volts, it operates. In the operating environment, the temperature is -40°C~85°C TA. A flip flop of this type is classified as a D-Type. It belongs to the 10ELseries of FPGAs. You should not exceed 2.8GHzin its output frequency. There is 29mA quiescent consumption. There have been 8 terminations. The 10EL51 family contains this object. It is powered from a supply voltage of 5V. It is mounted by the way of Surface Mount. There are 8pins on it. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. There is a base part number FF/Latchesfor the RS flip flops. An electronic part designed with 1bits is used in this application. As soon as Vsup reaches 5.7V, the maximum supply voltage is reached. It is imperative that the supply voltage (Vsup) is maintained above 4.2Vin order to ensure normal operation. The superior flexibility of this circuit is achieved by using 1 circuits. In view of its reliability, this D flip flop is a good fit for RAIL. A power supply of -5.2Vis required to operate it. Additionally, it is characterized by NECL MODE: VCC = 0V WITH VEE = -4.2V TO -5.7V.

MC10EL51DTG Features

Tube package
10EL series
8 pins
1 Bits
-5.2V power supplies

MC10EL51DTG Applications

There are a lot of ON Semiconductor MC10EL51DTG Flip Flops applications.

• Reduced system switching noise
• Memory
• Memory
• ESD protection
• Counters
• Cold spare funcion
• Storage Registers
• 2 – Bit synchronous counter
• CMOS Process
• Clock pulse