MC10EL51DTR2G

MC10EL51DTR2G Overview

As a result, it is packaged as 8-TSSOP, 8-MSOP (0.118, 3.00mm Width). Package Tape & Reel (TR)embeds it. It is configured with Differentialas an output. It is configured with a trigger that uses a value of Positive, Negative. The electronic part is mounted in the way of Surface Mount. A voltage of -4.2V~-5.7Vis required for its operation. It is at -40°C~85°C TAdegrees Celsius that the system is operating. The type of this D latch is D-Type. The FPGA belongs to the 10EL series. Its output frequency should not exceed 2.8GHz. It consumes 29mA of quiescent current without being affected by external factors. There have been 8 terminations. It is a member of the 10EL51 family. Power is supplied from a voltage of 5V volts. This electronic part is mounted in the way of Surface Mount. A total of 8pins are provided on this board. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. It is included in FF/Latches. There are 1bits in this flip flop. The maximal supply voltage (Vsup) reaches 5.7V. Normal operation requires a supply voltage (Vsup) above 4.2V. Its superior flexibility is attributed to its use of 1 circuits. As a result of its reliable performance, this T flip flop is suitable for TAPE AND REEL. An electrical current of -5.2V volts is applied to it. Additionally, you may refer to the D latch's additional NECL MODE: VCC = 0V WITH VEE = -4.2V TO -5.7V.

MC10EL51DTR2G Features

Tape & Reel (TR) package
10EL series
8 pins
1 Bits
-5.2V power supplies

MC10EL51DTR2G Applications

There are a lot of ON Semiconductor MC10EL51DTR2G Flip Flops applications.

• Convert a momentary switch to a toggle switch
• Data transfer
• Common Clocks
• Test & Measurement
• Buffered Clock
• ESD performance
• QML qualified product
• EMI reduction circuitry
• Consumer
• ATE