MC10EP131FAR2G

MC10EP131FAR2G Overview

The flip flop is packaged in a case of 32-LQFP. Package Tape & Reel (TR)embeds it. T flip flop uses Differentialas the output. It is configured with the trigger Positive, Negative. There is an electric part mounted in the way of Surface Mount. The JK flip flop operates at a voltage of -3V~-5.5V. It is operating at -40°C~85°C TA. A flip flop of this type is classified as a D-Type. In this case, it is a type of FPGA belonging to the 10EP series. A frequency of 3GHzshould be the maximum output frequency. D latch consists of 1 elements. There is a consumption of 120mAof quiescent energy. A total of 32terminations have been recorded. You can search similar parts based on 10EP131. The D flip flop is powered by a voltage of 3.3V . In terms of electronic devices, this device belongs to the 10Efamily of devices. The electronic part is mounted in the way of Surface Mount. With its 32pins, it is designed to work with most electronic flip flops. This device has Positive Edgeas its clock edge trigger type. It is part of the FF/Latchesbase part number family. There are 4bits in this flip flop. Vsup reaches its maximum value at 5.5V. A normal operating voltage (Vsup) should remain above 3V. Its superior flexibility is attributed to its use of 4 circuits. Considering the reliability of this T flip flop, it is well suited for TAPE AND REEL. A power supply of -5.2Vis required to operate it. In addition, you can refer to the additinal NECL MODE: VCC = 0V WITH VEE = -3V TO -5.5V of the D latch.

MC10EP131FAR2G Features

Tape & Reel (TR) package
10EP series
32 pins
4 Bits
-5.2V power supplies

MC10EP131FAR2G Applications

There are a lot of ON Semiconductor MC10EP131FAR2G Flip Flops applications.

• Differential Individual
• Safety Clamp
• Storage registers
• Divide a clock signal by 2 or 4
• Buffer registers
• Synchronous counter
• Data storage
• Functionally equivalent to the MC10/100EL29
• Reduced system switching noise
• Pattern generators