MC10EP29DTR2

MC10EP29DTR2 Overview

The flip flop is packaged in a case of 20-TSSOP (0.173, 4.40mm Width). Package Tape & Reel (TR)embeds it. There is a Differentialoutput configured with it. Positive, Negativeis the trigger it is configured with. Surface Mountis occupied by this electronic component. The supply voltage is set to -3V~-5.5V. -40°C~85°C TAis the operating temperature. It belongs to the type D-Typeof flip flops. In this case, it is a type of FPGA belonging to the 10EP series. It should not exceed 3GHzin terms of its output frequency. As a result, it consumes 57mA quiescent current. There are 20 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. This D latch belongs to the family of 10EP29. It is powered by a voltage of 3.3V . The electronic device belongs to the 10Efamily. It is mounted in the way of Surface Mount. A total of 20pins are provided on this board. Its clock edge trigger type is Positive Edge. This device has the base part number FF/Latches. In this case, the maximum supply voltage (Vsup) reaches 5.5V. The supply voltage (Vsup) should be kept above 3V for normal operation. The superior flexibility of this product is achieved by using 2 circuits. Considering the reliability of this T flip flop, it is well suited for TAPE AND REEL. There is also a characteristic of NECL MODE: VCC = 0V WITH VEE = -3V TO -5.5V. -50mAis set as the high level output current. In the low level output current setting, the current is set to 50mA.

MC10EP29DTR2 Features

Tape & Reel (TR) package
10EP series
20 pins

MC10EP29DTR2 Applications

There are a lot of ON Semiconductor MC10EP29DTR2 Flip Flops applications.

• Synchronous counter
• Storage registers
• Bus hold
• ATE
• Matched Rise and Fall
• Registers
• Differential Individual
• Convert a momentary switch to a toggle switch
• Data storage
• Data transfer