MC10EP31DTG

MC10EP31DTG Overview

In the form of 8-TSSOP, 8-MSOP (0.118, 3.00mm Width), it has been packaged. A package named Tubeincludes it. As configured, the output uses Differential. The trigger it is configured with uses Positive Edge. The electronic part is mounted in the way of Surface Mount. A supply voltage of -3V~-5.5V is required for operation. Currently, the operating temperature is -40°C~85°C TA. This electronic flip flop is of type D-Type. In FPGA terms, D flip flop is a type of 10EPseries FPGA. A frequency of 3GHzshould be the maximum output frequency. It consumes 45mA of quiescent In 8terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. It is a member of the 10EP31 family. It is powered by a voltage of 3.3V . An electronic device belonging to the family 10Ecan be found here. In this case, the electronic component is mounted in the way of Surface Mount. A total of 8pins are provided on this board. Its clock edge trigger type is Positive Edge. The part is included in FF/Latches. 1bits are used in its design. There is a 5.5Vmaximum supply voltage (Vsup). Normal operation requires a supply voltage (Vsup) above 3V. Using 1 circuits, it is highly flexible. As a result of its reliable performance, this T flip flop is suitable for RAIL. The system runs on a power supply of -5.2V watts. As an additional reference, you may refer to electronic flip flop NECL MODE: VCC = 0V WITH VEE = -3.0V TO -5.5V.

MC10EP31DTG Features

Tube package
10EP series
8 pins
1 Bits
-5.2V power supplies

MC10EP31DTG Applications

There are a lot of ON Semiconductor MC10EP31DTG Flip Flops applications.

• Shift Registers
• Buffered Clock
• Power down protection
• Divide a clock signal by 2 or 4
• 2 – Bit synchronous counter
• Circuit Design
• Set-reset capability
• Safety Clamp
• ATE
• Matched Rise and Fall